Water Expert Andy Ball: Salt in Softeners


Make text smaller Make text larger



Photos



  • Andy Ball



How much salt should my softener use?


1. An average softener with 1 cu. ft. of resins (30,000 grain, 10 ” x 44 ” tank) should use about 6-8 lbs. per regeneration to achieve an economical 24,000 grain capacity (hardness in grains divided into grains of capacity results in the gallons of water that can be treated before resins is exhausted).

2. The national average is 60 lbs. per month, but that can vary depending upon the quantity and the quality of water being treated.

Andy Ball
862-354-7698




Make text smaller Make text larger

Comments

Pool Rules



MUST READ NEWS

Uncertainty shadows Pennsylvania's debate over nuclear power
By Marc Levy
Four decades after Three Mile Island became shorthand for America's worst commercial nuclear power accident, financial rescues of nuclear power plants are...

Read more »
Image

Pike County is getting new paper-trail voting equipment
— Pike County will replace its voting machines with voter-verifiable paper trail equipment by the 2020 presidential primary, the...
Read more »
Image

Pike's Peek
Here's a clue that inspires warm thoughts on a cold February night: where have you seen this neat array of firewood? If you think you know, fill out the form below.
Read more »
Image

Pike's Peek
Good work by last week's "Peekers."
Pike County Commissioner Matt Osterberg writes that the detail in last week's clue may be found at the "County Building on...

Read more »
Image

VIDEOS



Subscribe to our mailing list

* indicates required
Community Newspapers



MOST READ

Where in answers
Pike's Peek
  • Feb 21, 2019
Where in clues
Pike's Peek
  • Feb 21, 2019

MOST COMMENTED



Weather in Milford, PA